(ETSI TS 102 694-2, ETSI TS 102 695-2)
Micropross proposes a test library, on top of the MP300 TC3, allowing to perform electrical and protocol test of SWP enabled U-SIM, following the requirement of the ETSI (ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI)). This solution is validated by Global Platform.
SWP (Single Wire Protocol) is the communication protocol between the mobile handset and the UICC that enables the NFC application to reside on the U-ICC.
The HCI (Host Controller Interface) provides a logical interface on top of the SWP to support the creation of a host network and support contactless applications on the U-ICC
What we propose, is a test platform that allows to simulate a CLF, and therefore test the good behaviour of the U-SIM following the test methods defined in the ETSI specifications ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI).
The main features of this SWP/HCI test library for U-SIM are :
- Test of a U-SIM according to the standards ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI)
- Fully automated generation of test reports
- Automated test sessions
- Test cases validated by the GCF, PTCRB, and GlobalPlatform
- Solution widely deployed at validation laboratories
The test session happens in a very simple manner.
First, the user inserts the U-SIM card inside the MP300 TC3.
Then, the user starts the software test tool, selects which test cases he wants to play.
Finally, the user collects the test results, generates test reports, and analyses the failures
Hardware platform :
Test case coverage : 100% of the ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI) test specifications
This solution will typically be used in the following contexts :
- debug of the SWP interface of a U-SIM
- debug of the HCI stack of a U-SIM
- conformance testing